Your browser doesn't support javascript.
loading
Mostrar: 20 | 50 | 100
Resultados 1 - 4 de 4
Filtrar
Mais filtros










Base de dados
Intervalo de ano de publicação
1.
J Stomatol Oral Maxillofac Surg ; 118(1): 2-4, 2017 Feb.
Artigo em Inglês | MEDLINE | ID: mdl-28330569

RESUMO

INTRODUCTION: Stability in orthognathic surgery is nowadays considered as efficient and adequate. The objective of this study was to determine and to compare the mechanical resistance to vertical load of a Le Fort I advancement osteotomy stabilized by mean of two different osteosynthesis techniques, one using two 10-hole pre-bent T-shaped plates, the other using four manually bent 4-hole L- and J-shaped plates. MATERIEL AND METHODS: Standardized Le Fort I advancement osteotomies have been made on polyurethane models. The maxillary advancement was 5mm. Two groups of five models each were created. Group 1 was stabilized by mean of two 10-hole pre-bent T-shaped plates fixed by monocortical screws in the paranasal region. Group 2 was stabilized by mean of manually bent four 4-hole L-shaped plates fixed monocortical screws in the zygomatic and paranasal regions. A testing machine was used to load vertically the models at the range of 1mm/min linear displacement until peak load and system failure. Statistical analysis was realized using ANOVA and t-test, considering P as significant if <0.005. RESULTS: The maximal tolerated load was 15N in group 1and 42.71N in group 2 (P=0.003). DISCUSSION: The use of two T-shaped 10-holes pre-bent plates allows for less resistance in vertical loading than the use of four 4-holes manually bent L-shaped plates.


Assuntos
Placas Ósseas , Fixação Interna de Fraturas , Osteotomia de Le Fort , Estresse Mecânico , Placas Ósseas/efeitos adversos , Parafusos Ósseos/efeitos adversos , Desenho de Equipamento , Falha de Equipamento , Análise de Falha de Equipamento , Fixação Interna de Fraturas/instrumentação , Fixação Interna de Fraturas/métodos , Humanos , Técnicas In Vitro , Teste de Materiais/métodos , Fenômenos Mecânicos , Modelos Anatômicos , Osteotomia de Le Fort/instrumentação , Osteotomia de Le Fort/métodos
2.
Int J Morphol ; 33(3): 1146-1150, 2015 Sep.
Artigo em Inglês | MEDLINE | ID: mdl-27840552

RESUMO

Electrical stimulation has been used in different conditions for tissue regeneration. The aim of this study was to analyze the tissue response of defects created in rabbit skulls to electrical stimulation. Two groups were formed, each with 9 New Zealand rabbits; two 5 mm defects were made, one in each parietal, with one being randomly filled with autogenous bone extracted as particles and the other maintained only with blood clotting. The rabbits were euthanized at 8 weeks and 15 weeks to then study the samples collected histologically. In the 8-week analysis bone formation was observed in the defects in the test and control filled with bone graft, whereas the defects with clotting presented a very early stage of bone formation with abundant connective tissue. At 15 weeks an advanced stage of bone regeneration was identified in the defects with bone graft, whereas no significant differences were found in the electrically stimulated defects. In conclusion, electrical stimulus does not alter the sequence of bone formation; new studies could help establish patterns and influences of the stimulus on bone regeneration.

SELEÇÃO DE REFERÊNCIAS
DETALHE DA PESQUISA
...